arm discussion forum thread list

Hello

I can not found a Jumper J8. I can just find the J8 display-connector.
Is it posible that J1000 is the nand flash select? But it do not have any effect
on my board :(

* Posted by: fakulatus 2010-7-28 16:34:46 *

J8? <--- 〖Reply to this〗

Hi J 1000 is BMS (boot mode selection). to erase nand flash memorry you
can enter wince e-boot stage ,in e-boot (press space before enter wince
image run stage) then on e-boot you can see a selection item about erase
the whole nand flash .

* Posted by: Embest_Yangkun 2010-8-16 16:55:46 *

Report any problems to the webmaster.