Message Showing
| Back to thread list | Show all messages of this thread |
| nand erase <--- 〖Reply to this〗 |
| hello
you can see the hardware schematic, the J8 is the nand flash select chip,so you can see the board,if the j8 is jumped,it will boot from the nand flash,if the J8 is jumped,and the nand flash had nandflash_at91sam9261ek.bin,it will not connect sam-ba,you should delect the nand flash,if the board had information,system in the original implementation of UBOOT environment,use command: nand erase . * Posted by: shujun 2009-11-25 9:03:33 * |
| J8? <--- 〖Reply to this〗 |
| Hello
I can not found a Jumper J8. I can just find the J8 display-connector. Is it posible that J1000 is the nand flash select? But it do not have any effect on my board :( * Posted by: fakulatus 2010-7-28 16:34:46 * |
| J8? <--- 〖Reply to this〗 |
| Hi J 1000 is BMS (boot mode selection). to erase nand flash memorry you
can enter wince e-boot stage ,in e-boot (press space before enter wince image run stage) then on e-boot you can see a selection item about erase the whole nand flash . * Posted by: Embest_Yangkun 2010-8-16 16:55:46 * |
| Copyright ©2002 Embest Info&Tech Co.,LTD. All rights reserved. |
| Report any problems to the webmaster. |
